How to view ONU information on BDCOM OLT ?

I will give an example of viewing information about ONT (ONU) on EPON OLT BDCOM P3310C, on other models it is essentially the same.

Let's connect to the OLT and go to the configuration mode:

• enable
• config

You can view the list of ONUs with the commands:

• show epon onu-information
• show epon active-onu
• show epon inactive-onu

An example of viewing MAC addresses on a port or ONU:

• show mac address-table interface EPON0/1
• show mac address-table interface EPON0/1:5
• show mac address-table brief

Viewing the optical power that comes from the OLT to the ONU (ONU RX):

• show epon interface ePON 0/1:5 onu ctc optical-transceiver-diagnosis

Viewing the optical power that comes from the ONU to the OLT (OLT RX):

• show epon optical-transceiver-diagnosis interface EPON 0/1

View ONU models and firmware version:

• show epon onu-software-version
• show epon onu-software-version interface EPON 0/1

View description and status of interfaces:

• show interface brief

ONU ethernet port status and statistics view:

• show epon interface epON 0/1:1 onu port 1 state
• show epon interface epON 0/1:1 onu port 1 statistics
• show epon interface epON 0/1:1 onu mac address-table

You can also see which ONUs are registered in the saved and active OLT configuration:

• show configuration
• show running-config

ONU reboot example:

• epon reboot onu interface ePON 0/1:1

Read Also :

• Adding ONU with trunk port to BDCOM OLT - New!

• BDCOM How to reboot ONU

• BDCOM OLT All Commands

• How to Register and remove ONT from BDCOM OLT configuration ? - New!